2. Insert and tighten the two screws using the Phillips #2 screwdriver.
Figure 11 Installing screws
Install the system in the cabinet
This procedure is used to install the system in the cabinet.
About this task
WARNING
The system is heavy and should be installed in a cabinet by two people. To avoid personal injury and/or
damage to the equipment, do not attempt to install the system in a cabinet without a mechanical lift and/or help
from another person.
Procedure
1. At front of the cabinet, pull the inner slide rails out of the cabinet until they lock into place.
Figure 12
Pull the inner rails out of the cabinet
2. Locate the rear rail standoff on each side of the system. Position the system above the rails and lower the rear
rail standoffs into the rear J-slots on the slide assemblies.
3. Rotate the system downward until all the rail standoffs are seated in the J-slots.
R640 Equipment Installation
Dell EMC VxFlex Ready Node Server Installation Guide 33
To Next Page
Loading...
