Installation and Setup Installing a PS6000 Array
2–9
Figure 2-4: Recommended Power Configuration - PS6000
Step 2: Connect the Array to the Network
The PS6000 array includes two control modules of the same type and color. Each
control module has four network interface ports, labeled from 0 to 3.
One functioning network connection is required for array operation. Multiple
network connections are recommended for performance and high availability. See
Table 2-1 for additional network recommendations.
Obtain two to eight network cables. Network cables are not included in the array
shipping box. See Table 2-4 for supported network cable types.
At a minimum, connect network cables to Ethernet 0 on both control modules and
then connect the cables to a network switch. See Figure 2-5.
To Next Page
Loading...
