NOTE: After removing the screws, lift the system board from the top left and right sides of the heat sink. Ensure the
connectors are released from the ports and pins on the left and right sides of your computer.
NOTE: Place the system board on a clean and flat surface.
16. After performing all the above steps, lift the system board off the palm-rest and keyboard assembly along with the USB
board, and heat sink.
17. Turn the system board over and remove USB board, and heat sink.
18. After performing all the above steps, you are left with system board.
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
41
To Next Page
Loading...
