Steps
1. Slide the USB board into the M.2 card slot on the system board and align the screw holes on the USB board to the screw
holes on the system board.
2. Replace the two screws (M2x4) that secure the USB board to the system board.
3. Turn the system-board assembly over.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the wireless card.
4. Install the solid-state drive.
5. Install the rear cover.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Ethernet and audio board
Removing the ethernet and audio board
Prerequisites
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the removal
procedure.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
Removing and installing Field Replaceable Units (FRUs)
77
To Next Page
Loading...
