NOTE: The system board can be removed as an assembly with the fan and heat-sink assembly, ethernet and audio
board, and USB board attached.
About this task
The following images indicate the location of the power button and provide a visual representation of the removal procedure.
Steps
1. Remove the two screws (M2x2) that secure the power-button board assembly to the palm-rest and keyboard assembly.
2. Peel the power-button cable from the palm-rest and keyboard assembly.
3. Lift the power-button board assembly off the palm-rest and keyboard assembly.
4. Remove the screw (M2x2) that secures the power button to the palm-rest and keyboard assembly.
5. Lift the power button off the palm-rest and keyboard assembly.
Installing the power button
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power button and provides a visual representation of the installation
procedure.
82
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
