Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Procedure to move the M.2 solid-state drive screw mount for solid-
state drive slot 2
About this task
NOTE: Both M.2 solid-state drive slots on this computer support the following solid-state drive configurations:
● M.2 2230 solid-state drive
● M.2 2280 solid-state drive
NOTE: Depending on the configuration ordered, a M.2 2230 or 2280 solid-state drive may be installed into both slot 1 and
2. If you are installing a solid-state drive into slot 2 by yourself, only a M.2 2280 SSD, paired with a Dell thermal shield is
recommended.
If you are replacing the solid-state drive of a different form factor other than the one removed, perform the following procedure
to move the location of the solid-state drive screw mount.
Steps
1. Push the solid-state drive screw mount outwards to remove it from the screw-mount slot of the palm-rest and keyboard
assembly.
2. Rotate the solid-state drive screw mount 180 degrees and slide it into the M.2 2280 screw-mount slot.
42
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
