Dell IN2030M - Connecting Your Monitor; Removing the Stand

To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer.Donotusebothcablesonthesamecomputer.Useboththecablesonlywhentheyareconnectedtotwodifferentcomputerswith
appropriate video systems.
Connecting the Blue VGA Cable

Connecting the white DVI cable (for IN2030M only)

Removing the Monitor Stand
Attaching the Dell Soundbar
WARNING: Before you begin any of the procedures in this section, follow the Safety Instructions.
CAUTION: The graphics are used for the purpose of illustration only. Appearance on the computer may vary.


After placing the monitor panel on a soft cloth or cushion, complete the following steps to remove the base:
1.
Use a long screwdriver to push the release latch located in a hole just above the stand.
2.
Once the latch is released, remove the base away from the monitor.