Removing the I/O board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Follow the procedure from step 1 to step 4 in “Removing the hard drive”
(Only for computers shipped with a hard drive).
Procedure
1 Peel off the tape that secures the sensor-board cable to the I/O board.
2 Open the latch and disconnect the sensor-board cable from the I/O
board.
35
To Next Page
Loading...
