Steps
1. Align the screw hole on the M.2 2230 slid-state drive with the screw hole on the M.2 2230 solid-state drive bracket.
2. Replace the screw (M2x2) that secures the M.2 2230 solid-state to the M.2 2230 solid-state drive bracket.
3. Flip over the M.2 2230 solid-state drive assembly.
4. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 solid-state drive slot on the system board.
5. Slide the M.2 2230 solid-state drive into the M.2 solid-state drive slot on the system board.
6. Replace the screw (M2x2) that secures the M.2 2230 solid-state drive bracket to the palm-rest and keyboard assembly.
7. Place the Mylar over the M.2 2230 solid-state drive and the solid-state drive bracket.
8. Adhere the Mylar that covers the M.2 2230 solid-state drive and the solid-state drive bracket.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
20
Removing and installing components
To Next Page
Loading...
