About this task
The following image(s) indicate the location of the right fan and provides a visual representation of the removal procedure.
Steps
1. Peel the Mylar off the system board to reveal the right-fan cable.
2. Peel the tape that secures the right-fan cable (FAN1) to the system board.
3. Remove the two screws (M2x3) that secure the right fan to the palm-rest and keyboard assembly.
4. Disconnect the right-fan cable (FAN1) from the system board.
5. Lift the right fan off the palm-rest and keyboard assembly.
Installing the right fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: The left fan and the right fan have the same specifications.
The following image(s) indicate the location of the right fan and provides a visual representation of the installation procedure.
Removing and installing components
29
To Next Page
Loading...
