Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
Steps
1. Using the alignment posts, place the battery on the palm-rest and keyboard assembly.
2. Lift the Mylar to access the battery connector and connect the battery cable to the system board.
3. Place the Mylar over the M.2 solid-state drive.
4. Replace the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Removing and installing components 17
To Next Page
Loading...
