Replacing the power and volume-
buttons board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Place the power and volume-buttons board in the slot on the palmrest and
keyboard assembly and snap the tabs into place.
2 Adhere the tape that secures the power and volume-buttons board to the
palmrest and keyboard assembly.
3 Using the alignment post, place the left speaker on the palmrest and keyboard
assembly and snap it into place.
4 Route the power and volume-buttons board cable through the routing guides on
the speaker.
5 Connect the power and volume-buttons board cable to the I/O board.
6 Adhere the tapes that secure the power and volume-buttons board cable to the
palmrest and keyboard assembly.
Post-requisites
1 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
2 Replace the battery.
3 Replace the base cover.
40
To Next Page
Loading...
