Replacing the touch pad
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Slide the tabs on the touch pad into the slots on the palmrest and keyboard
assembly.
2 Adhere the tape that secures the touch pad to the palmrest and keyboard
assembly.
3 Align the screw holes on the touch-pad bracket with the screw holes on the
palmrest and keyboard assembly.
4 Replace the screws that secure the touch-pad bracket to the palmrest and
keyboard assembly.
5 Slide the touch-pad cable into the touch-pad connector and press down the
latch to secure the cable.
6 Slide the keyboard cable into the keyboard daughter-board connector and press
down the latch to secure the cable.
Post-requisites
1 Replace the battery.
2 Replace the base cover.
49
To Next Page
Loading...
