Replacing the Windows-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Slide the Windows-button board cable into the connector on the Windows-
button board and press down the latch to secure the cable.
2 Adhere the tape to the connector on the Windows-button board.
3 Turn the Windows-button board and align the screw hole on the Windows-
button board with the screw hole on the display bezel.
4 Replace the screw that secures the Windows-button board to the display bezel.
5 Turn the display-panel assembly over.
Post-requisites
1 Follow the procedure from step 4 to step 5 in “Replacing the display panel”.
2 Replace the display assembly.
3 Replace the battery.
4 Replace the base cover.
93
To Next Page
Loading...
