Steps
1. Align the ports on the I/O board to the slots on the palm-rest and keyboard assembly.
2. Place the I/O board on the palm-rest and keyboard assembly.
3. Align the screw hole on the I/O board to the screw hole on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O-board cable to the connector on the I/O board and close the latch.
6. Connect the power-button with fingerprint-reader cable to the connector on the I/O board and close the latch.
7. Connect the coin-cell battery cable to the I/O board.
8. Close the left-display hinge and align the screw holes on the left-display hinge with the screw holes on the I/O board.
9. Replace the two screws (M2.5x4) that secure the left-display hinge to the I/O board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-button
Removing the power-button
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the fan.
4. Remove the display assembly.
5. Remove the I/O board.
40
Removing and installing components
To Next Page
Loading...
