Dell Inspiron 1420 - Removing and Replacing the Camera Module

Great user manuals database on UserManuals.info
Back to Contents Page
 Camera Module
Dell™Inspiron™1420/DellVostro™1400
Service Manual
Removing and Replacing the Camera Module
Removing and Replacing the Camera Module



1. Follow the instructions in Before You Begin.

2. Remove the display bezel (see Removing the Display Bezel).

3. Lift the cable securing tab, and then gently pull the camera module cable from the connector.

4. Remove the two M2 x 3-mm screws securing camera module to the display assembly.

5. Gently lift the camera module.

6. Install the replacement camera and tighten the two M2 x 3-mm screws.

7. Insert the camera module cable in the connector and press down the securing tab.

8. Replace the display bezel (see Replacing the Display Bezel).
Back to Contents Page

CAUTION: Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface, such as the back panel on the computer.
1
display
2
screws (2)
3
camera
4
camera module