Next steps
1. Install the display bezel.
2. Install the hinge caps.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the base cover.
6. Exit service mode.
7. Install the SD card.
8. Follow the procedure in after working inside your computer.
Camera
Removing the camera
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD card.
3. Enter service mode.
4. Remove the base cover.
5. Remove the WLAN card.
6. Remove the display assembly.
7. Remove the hinge caps.
8. Remove the display bezel.
9. Remove the display panel.
About this task
Steps
1. Disconnect the camera cable from the camera module.
2. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
64
Removing and installing components
To Next Page
Loading...
