Table 12. Power
Options Description
Battery configuration
This section provides options to enable different power modes
on the computer. The options are as follows:
● Adaptive - battery settings are adaptively optimized based
on the users typical battery usage patterns (selected by
default).
● Standard - Fully charge the battery at a standard rate.
● ExpressCharge - The battery may be charged over a
shorter period using Dell's fast charging technology.
● Primarily AC use - The battery lifespan for users who
primarily operate their system while plugged in to an
external power source.
● Custom - Custom select when the battery starts and stops
charging.
○ Custom Charge Start
○ Custom Charge Stop
Advanced Configuration
Enable Advanced Battery Charge Configuration
This feature maximizes battery health while still supporting
heavy use during the work day. The section contains a toggle
switch that allows the user to enable or disable this feature
and set the daily times and work time periods (OFF by
default).
Peak Shift
This feature allows the computer to run on battery during
peak usage hours. The section contains a toggle switch that
allows the user to enable or disable this feature and set the
Peak Shift Start/End times and Peak Shift Charge Start/End
(OFF by default).
USB PowerShare
This setting contains a toggle switch which allows the user to
enable or disable this feature. It allows for any external USB
devices to charge via the designated USB PowerShare port,
even when the computer is on sleep mode (ON by default).
Thermal Management
This setting allows for cooling fan and processor heat
management to adjust system performance, noise and
temperature. The options available are as below:
● Optimized - Standard setting for cooling fan and processor
heat management (selected by default).
● Cool - Processor and cooling fan speed are adjusted for a
cooler system surface temperature.
● Quiet - Processor and cooling fan speed are adjusted to
reduce fan noise.
● Ultra Performance - Processor and cooling fan speed are
increased for more performance.
USB Wake Support
Block Sleep
Block Sleep
This section contains a toggle switch to allow the user to
enable or disable the system from entering Sleep(S3) mode in
the operating system (OFF by default).
NOTE: When enabled, it will not allow the system to go to
sleep, IRST is disabled and power options in the operating
system will be blank.
LID Switch
System setup 91
To Next Page
Loading...
