Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the speakers and provide a visual representation of the installation procedure.
Steps
1. Using the alignment posts, place the speakers on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:
Route the speaker cable along the bottom side of the palm rest, over the WLAN antenna cables (for models
shipped with WLAN antennas in the display assembly), and then secure the cable through the routing guides on the
palm-rest.
56 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
