Steps
Align the display bezel with the display back-cover and antenna assembly, and then gently snap the display bezel into place.
Next steps
1. Install the hinge caps.
2. Install the display assembly.
3. Install the wireless card.
4. Install the base cover.
5. Install the SD card.
6. Follow the procedure in After working inside your computer.
Hinges
Removing the hinges
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
NOTE: This procedure is applicable for systems with a plastic chassis only.
88 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
