Steps
1. Disconnect the battery cable from the system board, if applicable.
2. Remove the four (M2x3) screws that secure the battery to the palm-rest and keyboard assembly.
3. Remove the battery from the palm-rest and keyboard assembly.
NOTE:
When replacing the 4-cell battery, use a scribe push upward through the bottom-left screw hole to remove the
battery rubber stopper and transfer it to the new replacement 4-cell battery.
Installing the 4-cell battery
CAUTION: The information in this section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 61
To Next Page
Loading...
