Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedure
1 Connect the camera cable to the camera.
2 Align the camera to the alignment posts on the display back-cover and
snap the camera in place.
Post-requisites
1 Replace the display bezel.
2 Replace the display assembly.
3 Replace the system board.
4 Replace the heat sink.
5 Replace the I/O board.
6 Replace the wireless card.
7 Replace the memory module.
8 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
9 Follow the procedure from step 3 to step 7 in “Replacing the base cover”.
10 Follow the procedures from step 4 to step 5 in “Replacing the optical
drive”.
11 Replace the keyboard.
12 Replace the battery.
89
To Next Page
Loading...
