Steps
1. Peel off the tape that secures the display cable to the system board.
2. Open the latch, and disconnect the display cable from the system board.
3. Remove the screw (M2.5x3.5) and the two screws (M2.5x5) that secure the left display hinge to the system board.
4. Remove the three screws (M2.5x5) that secure the right display hinge to the system board.
5. Lift the palm-rest and keyboard assembly up to raise the display hinges.
6. Slide the palm-rest and keyboard assembly off the display assembly carefully.
38
Removing and installing components
To Next Page
Loading...
