3. Install the heat sink.
4. Install the wireless card.
5. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive in M.2 slot two.
6. Install the M.2 2230 solid-state drive or the M.2 2280 solid-state drive in M.2 slot one.
7. Install the battery.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the memory modules.
5. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive from M.2 slot one.
6. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive from M.2 slot two.
7. Remove the wireless card.
8. Remove the fan.
9. Remove the heat sink.
10. Remove the display assembly.
11. Remove the power-adapter port.
12. Remove the speakers.
13. Remove the power button with optional fingerprint reader.
14. Remove the touchpad.
15. Remove the I/O board.
16. Remove the system board.
NOTE: The system board can be removed along with the heat sink.
About this task
The figure indicates the location of the palm-rest and keyboard assembly and provides a visual representation of the removal procedure.
Removing and installing components
55
To Next Page
Loading...
