Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Using the alignment posts, align and place the left speaker on the palm-rest
assembly.
2 Replace the rubber grommets if they are pushed up while replacing the left
speaker.
3 Route the speaker cable through the routing guides on the palm-rest assembly.
4 Align and place the status-light board in the slot on the palm-rest assembly.
5 Using the alignment posts, align and place the right speaker on the palm-rest
assembly.
6 Replace the rubber grommets if they are pushed up while replacing the right
speaker.
7 Connect the speaker cable to the system board.
Post-requisites
Replace the base cover.
44
To Next Page
Loading...
