Dell Inspiron 1501 - Replacing the Display Assembly; Display Bezel


12. Lift the display up and away from the computer.
Replacing the Display Assembly

1. Place the display onto the computer base.

2. Replace the two M2.5 x 5-mm screws in the display hinge.

3. Securely route the display cable under the tabs in the cable channel.

4. Connect the display cable to the system board and tighten the captive screw.

5. Securely route the antenna cables under the tabs in the antenna cable channel. If a Mini-Card is installed, connect the antenna cables to the card (see
Replacing a Mini-Card).

6. Replace the keyboard (see Replacing the Keyboard).

7. Replace the hinge cover (see Replacing the Hinge Cover).

8. Close the display.

9. Replace the two M2.5 x 8-mm screws in the back of the computer and replace the two screw covers.

10. Turn the computer over and replace the two M2.5 x 8-mm screws in the bottom of the computer.
Display Bezel

1
M2.5 x 5-mm screws
(2)
2
display cable
3
display cable pull-tab
4
captive screw
5
antenna cables (2)
6
antenna cable
channel
7
standby switch
8
display cable connector on system
board
9
display cable channel
NOTICE: The standby switch is fragile and easily broken. Avoid knocking the switch when removing and replacing the display.
NOTE: Ensure the display and antenna cables are not twisted and are clear of the computer base before replacing the display.
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.