Steps
1. Ensure that the battery cable is disconnected, and disengage it from the tabs on the system board.
2. Remove the five screws (M2x4) that secure the battery to the palm-rest and keyboard assembly.
3. Lift the battery off the palm-rest and keyboard assembly.
Installing the battery
Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
18
Removing and installing components
To Next Page
Loading...
