Steps
1. Align the screw holes on the I/O board with the screw holes on the system board and palm-rest and keyboard assembly.
2. Align the ports on the I/O board with the slots on the palm-rest and keyboard assembly.
Note
3. Place the I/O board on the palm-rest and keyboard assembly.
4. Replace the M2x3 screw to secure the I/O board to the palm-rest and keyboard assembly.
5. Connect the I/O-board cable to the I/O board.
6. Close the latch and replace the clear adhesive tape.
7. Connect the fingerprint-reader cable to the I/O board and close the latch to secure the cable.
8. Connect the coin-cell battery from the I/O board.
9. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and
keyboard assembly.
10. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the battery.
2. Follow the procedure in After working inside your computer.
Power button
Removing the power button
Prerequisites
CAUTION: The information in this section is intended for authorized service technicians only.
1. Follow the procedure in Before working inside your computer.
Removing and installing components
39
To Next Page
Loading...
