About this task
The following image(s) indicate the location of the power button with fp and provides a visual representation of the installation
procedure.
Steps
1. Place the power button with optional fingerprint reader on the palm-rest and keyboard assembly.
2. Place the power-button board on the power button.
3. Align the screw holes on the power-button board with the screw holes on the palm-rest and keyboard assembly.
4. Replace the two screws (M2x3) to secure the power-button board to the palm-rest and keyboard assembly.
5. Connect the power-button board cable to I/O board and close the latch.
6. Connect the finger-print reader cable to the power-button board and close the latch.
7. Close the left display hinge and align the screw holes on the left display hinge with the screw holes on the palm-rest and
keyboard assembly.
8. Replace the two screws (M2.5x5) to secure the left display hinge to the palm-rest and keyboard assembly.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Removing and installing components
43
To Next Page
Loading...
