About this task
The following image(s) indicate the location of the speakers (woofers) and provides a visual representation of the installation
procedure.
Steps
1. Using the alignment posts, place the speakers (woofers) on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker (woofers) cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker (woofers) cable to the system board.
4. Connect the touchpad cable to the system board and close the latch.
5. Adhere the tapes that secure the antennae cables to the system board
Next steps
1. Install the memory module.
38
Removing and installing components
To Next Page
Loading...
