Steps
1. Place the power-adapter port into the slot on the palm-rest and keyboard assembly.
2. Close the right display hinge and align the screw holes on the right display hinge with the screw holes on the system board.
3. Replace the two screws (M2.5x5) that secure the right display hinge to the system board.
Next steps
1. Install the system board.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the battery.
5. Remove the power-adapter port.
6. Remove the left fan and the right fan.
7. Remove the display assembly.
8. Remove the speakers (woofers).
9. Remove the speakers (tweeters).
10. Remove the system board.
NOTE:
For this configuration where the computer is offered with GeForce RTX 3060, the system board can be removed
with the solid-state drive, memory module, and heat sink attached.
11. Remove the power-button board.
12. Remove the power button with optional fingerprint reader.
About this task
The following image(s) indicate the location of the palm-rest and keyboard assembly and provides a visual representation of the
removal procedure.
52
Removing and installing components
To Next Page
Loading...
