Steps
1. Using the alignment posts, place the speakers (tweeters) on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Connect the speaker (tweeters) cable to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Power-button board
Removing the power-button board
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the left fan.
4. Remove the heat sink.
About this task
The following image(s) indicate the location of the power-button board and provides a visual representation of the removal
procedure.
40
Removing and installing components
To Next Page
Loading...
