Steps
1. Connect the power-adapter port cable to the system board.
2. Adhere the tape that secures the power-adapter port to the system board.
3. Gently turn over the system board and place the system board on the palm-rest and keyboard assembly.
4. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three screws (M2x3) that secure the system board to the palm-rest and keyboard assembly.
6. Connect the speaker (tweeter) cable to the system board.
7. Connect the display cable to the system board and close the latch.
8. Adhere the tape that secures the display cable to the display cable connector.
9. Align the screw holes of the Type-C port-bracket with the screw holes of the system board.
Removing and installing components
49
To Next Page
Loading...
