Dell Inspiron 17 - Removing the Camera Module

Back to Contents Page
 Camera Module
Dell™Inspiron™N7010ServiceManual
Removing the Camera Module
Replacing the Camera Module



Removing the Camera Module

1. Follow the instructions in Before You Begin.

2. Remove the battery (see Removing the Battery).

3. Remove the module cover (see Removing the Module Cover).

4. Follow the instructions from step 4 to step 6 in Removing the Hard Drive.

5. Remove the optical drive (see Removing the Optical Drive).

6. Remove the keyboard (see Removing the Keyboard).

7. Remove the palm rest (see Removing the Palm Rest).

8. Remove the display assembly (see Removing the Display Assembly).

9. Remove the display bezel (see Removing the Display Bezel).

10. Remove the display panel (see Removing the Display Panel).

11. Carefully lift the camera module off the display cover.

12. Remove the tape that secures the camera cable to the camera module.

13. Disconnect the camera cable from the camera module.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
camera module
2
tape
3
camera cable