Dell Inspiron 17 - Removing the Memory Module(S); Replacing the Memory Module(S)

Back to Contents Page
 Memory Module(s)
Dell™Inspiron™N7010ServiceManual
Removing the Memory Module(s)
Replacing the Memory Module(s)



You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide at
support.dell.com/manuals for information on the memory supported by your computer.
Your computer has two user-accessible SODIMM sockets, labeled DIMM A and DIMM B, that can be accessed from the bottom of your computer.
Removing the Memory Module(s)

1. Follow the instructions in Before You Begin.

2. Remove the battery (see Removing the Battery).

3. Remove the module cover (see Removing the Module Cover).


4. Use your fingertips to carefully spread apart the securing clips on each end of the memory-module connector until the memory module pops up.

5. Remove the memory module from the memory-module connector.
Replacing the Memory Module(s)

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid eltectrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
NOTE: MemorymodulespurchasedfromDell™arecoveredunderyourcomputerwarranty.
CAUTION: To prevent damage to the memory-module connector, do not use tools to spread the memory module securing clips.
1
memory-module connector
2
securing clips (2)
3
memory module