Dell Inspiron 17 - Page 43


1. Follow the instructions in Before You Begin.

2. Align the notch in the memory module with the tab in the memory- module connector.

3. Slide the memory module firmly into the connector at a 45-degree angle, and press the memory module down until it clicks into place. If you do not hear
the click, remove the memory module and reinstall it.

4. Replace the module cover (see Replacing the Module Cover).

5. Replace the battery (see Replacing the Battery), or connect the AC adapter to your computer and an electrical outlet.


6. Turn on the computer.
As the computer boots, it detects the memory module(s) and automatically updates the system configuration information.
To confirm the amount of memory installed in the computer:
Windows Vista
®
:
Click Start ® Help and Support® Dell System Information.
Windows
®
7:
Click Start ® Control Panel® System and Security® System.
Back to Contents Page

CAUTION: If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you
install a memory module in the connector labeled "DIMM B".
NOTE: If the memory module is not installed properly, the computer may not boot.
1
tab
2
notch
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.