Installing the middle frame assembly
CAUTION: The information in this intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the base panel and provides a visual representation of the installation procedure.
Steps
Place the middle frame assembly on a flat and clean surface and perform the steps in the Post-requisites to install the
mid-frame assembly with antennas.
NOTE:
The middle frame assembly consists of the following:
● Middle frame
● Base panel
● Wireless antenna
Next steps
1. Install the display panel.
2. Install the power-button board with USB.
3. Install the stand hinges.
4. Install the microphones.
5. Install the speakers.
6. Install the system board.
7. Install theintegrated heat sink or discrete heat sink.
8. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, as applicable.
9. Install the wireless card.
10. Install the memory module.
Removing and installing Field Replaceable Units (FRUs)
99
To Next Page
Loading...
