Steps
1. Loosen the three captive screws that secure the base cover to the palm-rest and keyboard assembly.
2. Remove the four screws (M2x4) that secure the base cover to the palm-rest and keyboard assembly.
3. Starting from the top-left corner, use a plastic scribe to pry the base cover in the direction of the arrows to release the base
cover from the palm-rest and keyboard assembly.
CAUTION:
Do not pull on or pry the base cover from the side where the hinges are; doing so may damage the
base cover.
4. Pry the base cover and remove it from the palm-rest and keyboard assembly.
NOTE: The following steps are applicable only if you want to further remove any other component from your computer.
5. Using the pull tab, disconnect the battery cable from the system board.
14
Removing and installing components
To Next Page
Loading...
