Steps
After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.
NOTE: System board can be removed with heatsink attached.
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation
procedure.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the touchpad.
2. Install the power-adapter port.
3. Install the power button with fingerprint reader or power button.
4. Install the display assembly.
5. Install the system board.
6. Install the speakers.
7. Install the 4-cell battery or the 3-cell battery.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Removing and installing components
53
To Next Page
Loading...
