About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation
procedure.
Steps
1. Lift the mylar that covers the solid-state drive slot.
2. Slide the solid-state drive into the solid-state drive slot.
3. Slide the solid-state drive bracket and align the screw hole on the solid-state drive bracket with the screw hole on the
system board.
4. Replace the screw (M2x3) that secures the solid-state drive bracket to the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
22
Removing and installing components
To Next Page
Loading...
