Dell Inspiron 5391 - Display Hinges; Removing the Display Hinges; Installing the Display Hinges

Display hinges
Removing the display hinges
Prerequisites
NOTE: This procedure is not applicable to computers shipped with a WWAN configuration.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the display assembly.
6. Remove the display bezel.
About this task
The following image indicates the location of display hinges and provides a visual representation of the removal procedure.
Steps
1. Remove the four (M2.5x2.5) screws that secure the display hinges to the display back-cover.
2. Remove the two (M2x2) screws that secure the display hinges to the display back-cover.
3. Lift the display hinges off the display back-cover.
Installing the display hinges
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing components
55