Steps
Place the display back-cover on a flat surface.
NOTE: Antenna cables are a part of the palm-rest and keyboard assembly for computers shipping with WLAN
configurations.
Next steps
1. Install the camera.
2. Install the display cable.
3. Install the display panel.
4. Install the display hinges.
5. Install the display bezel.
6. Install the display assembly.
7. Install the WLAN card.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in After working inside your computer.
Display cable
Removing the display cable
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the display panel.
6. Remove the display bezel.
About this task
The following image indicates the location of display cable and provides a visual representation of the removal procedure.
60
Removing and installing components
To Next Page
Loading...
