Dell Inspiron 5391 - Display Back-Cover; Removing the Display Back-Cover

Steps
1. Adhere the camera to the display cable (tape) and connect the camera cable to the camera and turn it over.
2. Using the alignment post, turn the camera over and adhere to the display back-cover.
3. Adhere the tape that secures the camera to the display back-cover.
Next steps
1. Install the display panel.
2. Install the display bezel.
3. Install the display assembly.
4. Install the WLAN card.
5. Install the battery.
6. Install the base cover.
7. Follow the procedure in After working inside your computer.
Display back-cover
Removing the display back-cover
Prerequisites
NOTE:
This procedure is not applicable to computers shipped with a WWAN configuration.
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the WLAN card.
5. Remove the display assembly.
6. Remove the display bezel.
7. Remove the display hinges.
8. Remove thedisplay panel.
9. Remove the display cable.
58
Removing and installing components