12 | Removing the Battery
Removing the Battery
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
"Before Working Inside
Your Computer" on page 7. After working inside your computer, follow the
instructions in "After Working Inside Your Computer" on page 9.
For more safety best practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Prerequisites
Remove the base cover. See "Removing the Base Cover" on page 10.
Procedure
1 Remove the screws that secure the battery to the palm-rest assembly.
2 Disconnect the battery cable from the system board.
3 Remove the cable from the routing guides on the palm-rest assembly.
4 Lift the battery off the palm-rest assembly.
5 Turn the computer over, open the display, and press the power button for about
five seconds to ground the system board.
1 routing guide 2 cable
3 screws (2)
To Next Page
Loading...
