Screw Identification
Before removing and replacing components, photocopy the screw placemat as a tool to lay out and keep track of the screws. The placemat provides the
number of screws and the sizes.
Screw Placemat
System Components
NOTICE: If the computer is running Microsoft®Windows®Millennium Edition (Me), you need to download the operating system update utility for
Windows Me from http://support.dell.com and install it before you upgrade the BIOS.
NOTICE: When reinstalling a screw, you must use a screw of the correct diameter and length. Make sure that the screw is properly aligned with its
corresponding hole, and avoid over tightening.
Hard Drive Door Security:M3 x 5 mm
(1 each)
Keyboard to Bottom Case Assembly:M2.5 x 20
mm (4 each; plus one in memory module cover
and one in Mini PCI card cover)
Display to Base:M2.5 x 6 mm (3
each; 2 at back of computer; 1 at
flex-cable strain relief)
Display Bezel:Rubber screw covers (4
each)Plastic screw covers (2 each)M2.5
x 4 mm (6 each)
Display Panel to Display Mounting Bracket:M2
x 3 mm (6 each)
Flex-Cable Mounting Bracket to Top
Cover:M2.5 x 4 mm (1 each)
Video Card:M2.5 x 8 mm (3
each)
Palm Rest to
Bottom Case Assembly:M2.5 x 20 mm
(9 each)
Palm Rest Bracket:
M2.5 x 4 mm (2 each)
System Board:M2.5 x 4 mm captive washer
(3 each)
M2.5 x 20 mm (1 each)
LED Board:M2 x 4 mm (2 each)
Fan Assembly:M2 x 4 mm (3 each)
RJ-11/RJ-45 Board Assembly:M2.5 x 4 mm (1
each)
To Next Page
Loading...
