Dell Inspiron 8000 - Microprocessor Module Removal; Removing the Microprocessor Module

1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard assembly.
3. Remove the hinge cover.
4. Insert a pry stick into the latch mechanism at the left side of the microprocessor retaining clip and pry open the clip.
5. Lift out the thermal cooling assembly.
Microprocessor Module


Removing the Microprocessor Module
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the keyboard assembly.
3. Remove the hinge cover.
4. Remove the microprocessor thermal cooling assembly.
5. Remove the microprocessor module.
NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the thermal cooling assembly. The oils in your skin
reduce the heat transfer capability of the thermal pads.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface on the computer.
NOTICE: To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the thermal cooling assembly. The oils in your skin
reduce the heat transfer capability of the thermal pads.
NOTICE: When removing the microprocessor module, pull the module straight up. Do not bend the pins.