Dell Inspiron 8000 - LED Board and Fan Assembly; Removing the LED Board; Replacing the LED Board; Removing the Fan Assembly

Removing the LED Board
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the hinge cover.
3. Remove the two M2 x 4-mm screws.
4. Pull the LED board away from its connector.
Replacing the LED Board
1. Align the two screw holes with the two mounting holes on the bottom case assembly, and press the board into its connector.
2. Replace the two M2 x 4-mm screws.
Fan Assembly

Removing the Fan Assembly
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the system board.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface on the computer.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface on the computer.