Dell Inspiron 8000 - Memory Module Procedures; Removing the Memory Module Cover; Removing Memory Modules

4. Push the module latch toward the right side of the computer. Keep holding the latch open while pulling the device out of the media bay with the other
hand.
Memory Modules
Removing the Memory Module Cover
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the screw.
3. Disengage the metal tabs at the opposite end of the cover.

Removing Memory Modules

1. Remove the memory module cover.
2. To release a memory module from its connector, spread apart the tabs at each side of the module until the module pops up slightly.
3. Lift the memory module out of its connector.
NOTICE: Disconnect the computer and attached devices from electrical outlets and remove any installed batteries.
NOTICE: To avoid possible damage to the memory module from ESD, ground yourself by using a wrist grounding strap or by periodically touching an
unpainted metal surface on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you service the computer.
NOTICE: Make sure that the work surface is clean to prevent scratching the computer cover.
NOTICE: Handle memory modules with care. Do not touch the components on a module. Hold a module by its edges.