60 Adding Parts
www.dell.com | support.dell.com
3 Disconnect the computer from the electrical outlet.
4 Wait 10 to 20 seconds and then disconnect any attached devices.
5 Remove any installed PC Cards, batteries, and devices.
6 To ground yourself, periodically touch an unpainted metal surface on
the back of the computer while you work.
7 Handle components and cards by their edges, and avoid touching pins
and contacts.
8 Turn the computer over, and remove the screw from the Mini PCI card
cover.
9 Place your finger under the cover at the indentation and lift and slide
the cover open.
10 If a Mini PCI card is not already installed, go to step 11. If you are
replacing a Mini PCI card, remove the existing card:
a To release the Mini PCI card, spread the metal securing tabs until
the card pops up slightly.
b Disconnect the Mini PCI card from the wiring harness or internal
antenna, if present.
c Lift the Mini PCI card out of its connector and disconnect any
attached cables.
screw
Mini PCI card cover
To Next Page
Loading...
