66 Camera Module
Replacing the Camera Module
1
Follow the instructions in "Before You Begin" on page 9.
2
Connect the camera cable to the connector on the camera module.
3
Use the alignment posts on the display cover to snap the camera module
into position.
4
Replace the display bezel. See "Replacing the Display Bezel" on page 60.
5
Replace the display assembly. See "Replacing the Display Assembly" on
page 58.
6
Replace the hinge cover. See "Replacing the Hinge Cover" on page 53.
7
Follow the instructions from step 3 to step 7 in "Replacing the Palm-Rest
Assembly" on page 32.
8
Replace the battery. See "Replacing the Battery" on page 14.
CAUTION: Before turning on the computer, replace all screws and ensure that no
stray screws remain inside the computer. Failure to do so may result in damage to
the computer.
1 display cover 2 tabs (2)
3 camera module 4 camera cable
To Next Page
Loading...
